To connect Device:

1. Fasten the bracket with three M4 × 20 screws on the surface intended for mounting the Device (see Figure).
   Notice

   Bracket mounting screws are not included.
2. Hook the fixing bracket from the back panel of Device to the upper edge of the wall bracket.
3. Attach Device to the bracket with the supplied screw.

Demount Device in the reverse order.

Notice

Remove the cover before wiring. Fasten the base of Device to the bracket with a supplied screw.

Notice

The bushings need to be cut in accordance with the diameter of the lead-in cable.

To connect Device:

1. Prepare a place for mounting on the control panel (see Figure).
2. Install the gasket on the frame of Device to ensure degree of protection IP54.
3. Insert Device into a specially prepared hole on the front of the control panel.
4. Insert the supplied retainers into holes on the sides of Device.
5. Tighten supplied screws M4 x 35 in the holes of each retainer so that Device is firmly pressed to the front of the control panel.

Demount Device in reverse order.

To connect Device:

1. Prepare a place for mounting on the control panel (see Figure).
2. Install the gasket on the frame of Device to ensure degree of protection IP54.
3. Insert Device into a specially prepared hole on the front of the control panel.
4. Insert the supplied retainers into holes on the sides of Device.
5. Tighten supplied screws M4 x 35 in the holes of each retainer so that Device is firmly pressed to the front of the control panel.